Configuring a Cisco PIX Firewall

Firmware: version 4.x+

CollectorA TLC module that gathers or receives log messages from Log Sources.: Network CollectorA type of Collector that listens for Syslog and SNMP-based log messages from network devices. - Syslog

To configure a Cisco PIX firewall to send log messages to TLC, run the following commands at a prompt on the firewall:

enable

configure terminal

logging on

logging facility 20

logging trap informational

logging timestamp

logging host <interface> <Manager_IP>

where <interface> is the interface to which the Manager’s network is reachable, and

<Manager_IP> is the IP address or host name of the Manager that will host the Network Collector to which the firewall will send log messages.

Next	If you are performing initial configuration of your TLC environmentConsists of all TLC software, Managers, Log Sources, Monitored Assets, Collectors, and data in your TLC installation., see Configuring your TLC Environment. Otherwise, see Adding a Monitored Asset for a new Log Source.