Firmware: 9.x, 10.x
Collector: Network Collector - Syslog
If your F5 BIG-IP Server uses Syslog-ng, complete the steps in Configuring a Syslog-ng Module.
If your F5 BIG-IP Server uses Syslog, complete the following steps to configure the server to send log messages to TLC:
| 1. | Log in to the command line. |
| 2. | Enter the appropriate Configuration command for your version of F5 BIG-IP (see Table 126), where: |
<name> is the name of the Syslog server,
<manager_ip> is the host name or IP address of the TLC Manager that will collect log messages from this Log Source, and
<port> is the port with which the TLC Manager will listen for log messages (either 1468 for TCP, or 514 for UDP).
| 3. | Enter the appropriate Save command for your version of F5 BIG-IP (see Table 126). |
|
F5 BIG-IP version |
Configuration command |
Save command |
|---|---|---|
|
10.2.2 |
bigpipe syslog remote server {<name> {host <manager_ip>}}
|
bigpipe save all |
|
10.1.0 to 10.2.1 |
bigpipe syslog remote server {<name> {host <manager_ip>}} or tmsh modify sys syslog remote-servers add {<name>
{host <manager_ip> remote-port <port>}}
|
bigpipe save or tmsh save sys config |
|
10.0.0 to 10.0.x |
bigpipe syslog remote server {<name> {host <manager_ip>}} |
bigpipe save |
|
9.4.2 to 9.4.8 |
bigpipe syslog remote server <manager_ip> |
bigpipe save |
|
Next |
If you are performing initial configuration of your TLC environment, see Configuring your TLC Environment. Otherwise, see Adding a Monitored Asset for a new Log Source. |
|---|