Firmware: ALL
Collector: Network Collector - Syslog
To configure a Cisco CATOS switch to send log messages to TLC, run the following commands at a prompt on the switch:
set logging server enable
set logging server <Manager_IP>
set logging level all 5
set logging server severity 6
where <Manager_IP> is the IP address or host name of the Manager that will host the Network Collector to which the switch will send log messages.
|
Next |
If you are performing initial configuration of your TLC environment, see Configuring your TLC Environment. Otherwise, see Adding a Monitored Asset for a new Log Source. |
|---|